I made a simple bar bender for my own use.
Because i have small shop, i wanted to integrate it to my table.
Drilled holes trough two 7mm thick mild steel plates and my wooden 50mm thick table, at the same time.
Plate on top of the table is threaded, and lower plate is bolted to it throught table with 12 bolts.
Easy to expand later with templates with different shapes and radiuses.
Tools used:
Evolution evosaw 355 chop saw
Evolution evosaw 230 circular saw
Evolution evomag 50 mag drill.
Because i have small shop, i wanted to integrate it to my table.
Drilled holes trough two 7mm thick mild steel plates and my wooden 50mm thick table, at the same time.
Plate on top of the table is threaded, and lower plate is bolted to it throught table with 12 bolts.
Easy to expand later with templates with different shapes and radiuses.
Tools used:
Evolution evosaw 355 chop saw
Evolution evosaw 230 circular saw
Evolution evomag 50 mag drill.
0 Comments